Prolific USB Windows 8.1 and Windows 10 driver issue resolved – Robojax

Công Nghệ



This video will shows you step by step how to resolve the Prolific USB RS232 PL2303 issue for Windows 8.1 and Windows 10.

I will reply to all Subscriber’s 🔔 questions. So make sure to Subscribe.😊
Please like 👍 the video and type simple word in the comment. It helps me a lot.

Download the Prolific USB PL2303 :

How to use a breadboard (video) :
Cool smart watch review video

Learn Arduino in 30 Minutes (video):

Tutorial by Ahmad Shamshiri form Canada
****************************
Learn Arduino from a proven instructor with 100s of projects, code, wiring diagram in structured course in one place. Purchase Arduino Course at Udemy.com :
****************************
If you found this tutorial helpful, please support me so I can continue creating contents like this. Here is PayPal link
Get early access to my videos by becoming my Patreon and and have your name mentioned at end of very videos I publish on YouTube:
If you want to learn Arduino from proven instructor on **Udemy**:
Follow me on Facebook
Follow me on Twitter:
Follow me on Instagram:

Tutorial by Robojax.com
Get other projects code and learn Arduino

#robojax

Nguồn: https://seoredefined.com/

Xem thêm bài viết khác: https://seoredefined.com/cong-nghe/

37 thoughts on “Prolific USB Windows 8.1 and Windows 10 driver issue resolved – Robojax

  1. Hello, I have a device and i have RS232 comunication port, i set up to comunication from my laptop to this device, i use PLL2303 module tu convert from USB to RS232, but in a mistake moment, i revers two comunication line, TX of device to TX of PL2303 module and RX of device to RX of PL2303 module (two power line still accurate position). This can distroy port of my device of PL2303?

  2. I have a Baofeng T1 radio, factory reset. my problem is the reset and the display shows me 19 666.666 I do it with the up and down arrow and it does not show me more than the frequency 19. I am doing wrong or what happened inside the software I do not actually see set com3. and in the program (P) section followed by Read data From InterPhone (R), only one frequency comes out and nothing is seen anymore I want the 16 frequencies to be seen. I already installed firware on my computer, and updated flash. what will be

  3. Solved the problem, thanks so much. Extra info: I had already tried to update the driver automatically, which changed the error message shown on device manager to "PL2303HXA phased out since 2012 contact supplier" I had to manually uninstall this, then follow the instructions in the video and voila! Weather station working again.

  4. Hi RoboJax. I did as instructed but I am still getting an error. I was using the driver v1.4.0 on my old computer before upgrading to a new computer with windows 10. After plugging in the cable for my plotter it automatically updated to 3.8.25.0. I did as you instructed and after doing everything as instructed it says "windows encountered a problem installing the drivers for your device" "Windows found drives for you device but encountered an error while attempting to install them" "This device cannot start. (Code 10). It also tells me "If you know the manufacturer of your device, you can visit their website and check the support section for drivers." If you have any ideas, I would appreciate it.

  5. Thank you very much ! When i do like you discribe here, the driver does not recognize my prolific when i reconnect it . I have to reinstall it again and restart the computer then it works 🙁 Any ideas why? I have windows 10

    Thumb up 🙂

Leave a Reply

Your email address will not be published. Required fields are marked *